China breather valve for water tank Manufacturers Factory Suppliers

P/V vent is installed on the top of manhole to adjust the pressure between inner and outer of the tank, which can be set different opening pressure according to different usage, to avoid leakage and

Rotary oil display is widely used on multiple tank truck. It can show any oil product by turning the yellow turner. The material is enhanced plastic with feature of cold resistance and heat

Dip hole is a special accessory used to measure the oil level in the tank and to take oil samples. One is set on the top of each oil tank, most of which are located near the tank ladder platform. The

Oil-water Separator is installed on the control pipeline to extract the air source from air cylinder. When the pressure air gets into the oil-water separator, it will vapor the lubricate the air to

The hander valve is a two-channel three-vent structure for inner and outer exhausting.It is connected with all ports according to demanding. When pulling or pushing the handle, it will open or close

Manual bracket is used for manual type control system. The handle quantity can be customized according to clients’ requirement. One handle can control one manual valve. . When the handle is opening

Dust cap is used to keep vapor recovery system or connecting terminal clean, prevent the connecting port from broken, dust and water etc.

Vapor recovery coupler is Installed on the tank near close to discharge position, with quick coupling connection structure, as a necessary parts in the tank for controlling vapor in and out to

Vapor recovery valve will be installed on the vapor recovery pipeline on the top end of the tank, the downward outlet side is 45 degree angle with horizontal direction to effectively prevent from the

Vapor recovery valve is installed on the manhole to make sure no leakage when the tank rolling down. The outlet terminal is connected with vapor recovery pipe line by flexible pipe. when the tank is

Dust cap is used for protecting the API adaptor valve from dust, water and others and protecting the surface from broken. Dust gap is built in a gasket to protect the inside fuel flow out when the

API adaptor is installed on one side of the bottom of the tank, used for petrol, Gasoline,diesel and kerosene and such light fuel. With quick coupling connection structure, as an important parts for