Pay attention to the correct operation method in the use of the fuel dispenser, and pay attention to the relevant maintenance and maintenance items in the normal use and at the end of the use. In the long-term use of the fuel dispenser, it is inevitable that there will be operating problems due to improper operation, poor maintenance, or aging accessories. Regarding the malfunction of the fuel dispenser, the user should find out the cause and take corresponding measures.
The effect of the oil pump parts of the dispenser parts: through the effect of the anti-explosion motor, the oil is sucked from the oil tank into the interior of the dispenser manufacturer. The oil and gas separator is a component and equipment used for oil and gas separation before the oil enters the high pressure chamber and enters the flowmeter. Regarding the measurement volume of the oil flowing through the flowmeter components, a positive displacement flowmeter is generally selected. A certain amount of oil passing through will cause a certain displacement of the transmission shaft, and correspondingly, the sensor will output a certain number of pulses.
The main effect of solenoid valve components: solve the problem of overshoot during quantitative refueling to improve the accuracy of quantification; in the submersible pump tanker, it also has the effect of closing the oil pipeline when it is not refueling. The effect of self-sealing oil gun components: the application of oil filling, when the container is full, the oil gun is actively closed, which is a kind of anti-overflow equipment.
The fuel dispenser is planned according to the operating conditions of outdoor installation and selection of underground oil tanks. Therefore, the fuel dispenser should avoid the use of underground tanks and high-level oil tanks (the bottom of the tank is lower than the tanker oil pump and the upper part is higher than the tanker oil pump). If the tanker is above ground or high-level tank, how to debug the tanker should seal the vent of the separator to avoid oil spill.
The fuel dispenser should be beautiful and tidy in appearance. Frequent wiping, waxing, and timely removal of water vapor to prevent corrosion. For the cold north, the internal parts of the fuel dispenser should be disassembled and washed before the severe winter and covered with a protective cover. Protection to prevent the accumulation of water inside the tanker from forming freezing and cracking parts. The internal filter of the tanker should be cleaned regularly (once a week). Damage should be replaced, and the net cover should be washed with gasoline (the essential oil filter should be replaced regularly) and removed The dirt in the oil pump inlet and the oil tank should be cleaned regularly (about one year) to keep the oil clean.





