Power supply is required for an Eaglestar mobile fuel dispenser, just like our other products, such as EG1 (https://en.chinaeaglestar.com/products/showproduct.php?lang=en&id=25), EG3 (https://en.chinaeaglestar.com/products/showproduct.php?lang=en&id=15), EG5 (https://en.chinaeaglestar.com/products/showproduct.php?lang=en&id=16), EG6 (https://en.chinaeaglestar.com/products/showproduct.php?lang=en&id=22) and EG7 (https://en.chinaeaglestar.com/products/showproduct.php?lang=en&id=18).
When performing the power supply connection and ground connection for the mobile fuel dispenser, you need to see the following:
The 380V three-phase four-wire system standard is used for the power line of the mobile fuel dispenser, so it is recommended to use the 3*2.5+1*1.5 cable. Make the cable go through the power reserve pipe on the right side of the device, and connect it to the wiring in the explosion-proof electric cabinet. The connection point of the grounding wire lies at the base of the unloading pump. It is recommended to use the multistrand single-core copper wire of no less than 4 square meters.
