China breathe tank valve Manufacturers Factory Suppliers

P/V vent is installed on the top of manhole to adjust the pressure between inner and outer of the tank, which can be set different opening pressure according to different usage, to avoid leakage and

Dip hole is a special accessory used to measure the oil level in the tank and to take oil samples. One is set on the top of each oil tank, most of which are located near the tank ladder platform. The

The hander valve is a two-channel three-vent structure for inner and outer exhausting.It is connected with all ports according to demanding. When pulling or pushing the handle, it will open or close

Press button is installed on the end of fuel truck and far away from unloading position. As a emergency control switch for pneumatic system, press button is connected to emergency vent of pneumatic

Manual bracket is used for manual type control system. The handle quantity can be customized according to clients’ requirement. One handle can control one manual valve. . When the handle is opening

Anti-Overflow probe rod is used for oil tank. When there is down-unloading, it can monitor the inner state of the tank, working with the platform control system to make sure the safety and

Dust cap is used to keep vapor recovery system or connecting terminal clean, prevent the connecting port from broken, dust and water etc.

Vapor recovery coupler is Installed on the tank near close to discharge position, with quick coupling connection structure, as a necessary parts in the tank for controlling vapor in and out to

Vapor recovery valve will be installed on the vapor recovery pipeline on the top end of the tank, the downward outlet side is 45 degree angle with horizontal direction to effectively prevent from the

Dust cap is used for protecting the API adaptor valve from dust, water and others and protecting the surface from broken. Dust gap is built in a gasket to protect the inside fuel flow out when the

The gravity coupling is used far quickly discharge.We offer different size, the oblique angle design, more suitable for gravity discharging. make flow more faster, and effectively protect the the

Bottom valve, also called emergency shut-off valve, is installed on the bottom of tank, built in shut-off groove. His body will disconnect along the groove to realize the disconnection of the bottom